新聞資訊
鍛造工藝對Ti40阻燃鈦合金微觀組織與力學性能的影響
發布人：上海艾荔艾金屬材料有限公司bt990.com.cn
更新時間：2015-09-13
采用3種工藝鍛造出Ti40阻燃鈦合金90 mm方棒，對棒材的微觀組織及力學性能進行研究。
鍛造工藝對Ti40阻燃鈦合金微觀組織與力學性能的影響Effect of forging process on microstructures and mechanical properties of Ti40 burn resistant titanium alloy
采用3種工藝鍛造出Ti40阻燃鈦合金90 mm方棒，對棒材的微觀組織及力學性能進行研究，結果表明：減少鍛造火次、增加單火的變形量可以有效細化Ti40合金棒材的晶粒尺寸、提高組織均勻性，即使原始組織晶粒度不夠均勻，也能夠得到有效的改善。采用多火次小變形量鍛造易造成Ti40合金棒材微觀組織粗化和不均勻。Ti40合金棒材的拉伸強度和塑性對β晶粒尺寸變化不敏感，蠕變性能隨晶粒尺寸增大略有提高，用于鍛件成形的Ti40合金坯料應該進行充分鍛造，以避免因小變形量校正變形產生粗大和不均勻的組織。
90 mm tetragonal bars were made by forging Ti40 burn resistant titanium alloy through three different forging processes. The microstructures and mechanical properties of these forged bars were studied. The results show that it is a effective way to uniform and refine the beta grain size of Ti40 alloy bars through large deformation processing, even if the primary microstructures are not uniform. Multiple forging with small deformation can easily make the beta grain size of Ti40 alloy bars coarser and nonuniform. Tensile properties of Ti40 alloy bars are not very sensitive to the beta grain size. Creep properties slightly improve with the increase of beta grain size. To avoid coarse and nonuniform microstructures, forging blanks should be well performed before the final forging due to the small deformation modification.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://bt990.com.cn，轉載請注明出處。
前一頁：Ti40合金熱加工保溫過程中的組織演化
后一頁：Ti55鈦合金的熱壓縮變形及其本構方程