新聞資訊
PWHT溫度對Ti2AlNb合金EBW接頭顯微組織和顯微硬度的影響
發布人：上海艾荔艾金屬材料有限公司bt990.com.cn
更新時間：2015-09-07
研究了不同焊后熱處理(PWHT)溫度對Ti2AlNb合金電子束焊接(EBW)接頭顯微組織和顯微硬度的影響。
PWHT溫度對Ti2AlNb合金EBW接頭顯微組織和顯微硬度的影響Effects of PWHT temperature on microstructure and microhardness of EBW Ti2AlNb alloy joints
研究了不同焊后熱處理(PWHT)溫度對Ti2AlNb合金電子束焊接(EBW)接頭顯微組織和顯微硬度的影響。結果表明：焊態條件下，母材區是雙態組織，焊縫熔合區主要是柱狀B2相組織，焊接接頭的顯微硬度呈不均勻分布；經焊后熱處理，焊縫熔合區變?yōu)榫W(wǎng)籃組織；隨著熱處理溫度升高，熔合區中O相晶粒尺寸增大，數量減少，熱影響區為雙態組織，與母材區的差別在于等軸α2相邊緣針狀化。焊接接頭的顯微硬度經850、900 ℃熱處理后分布均勻。
The effects of post weld heat treatment(PWHT) temperature on the microstructure and microhardness of electron beam welding(EBW) Ti2AlNb alloy joints were studied, while the welding joint was treated at different PWET temperatures. The results show that the microstructure of base metal is duplex microstructure, while the fusion zone is mainly composed of columnar B2 phase in original state，and the microhardness of the original joint is not well-distributed. After PWHT, the column crystal of fusion zone is replaced by basketweave microstructure, and with the PWHT temperature increasing, the grain size of O phase in basketweave becomes larger while the quantity of O phase becomes smaller. At the same time, the heat-affected zone remains the microstructure of base metal besides the edge of α2?phase tend needle-like. Also, after PWHT conducted at 850 ℃ and 900 ℃, the microhardness of melting joint becomes much better distributed than the original one.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://bt990.com.cn，轉載請注明出處。
前一頁：冷軋及退火工藝對TA18管材組織和性能影響
后一頁：Ti-1300鈦合金熱處理后拉伸性能的回歸分析